Kitbike Engine Teardown and Rebuild
After getting new cylinders, pistons, heads, and wrist pins, now comes the job of repainting all the parts and fitting everything, along with the repaired slinger, back into the engine.Next Page
1. Fitting the wrist pins. I used a small hone to fit them correctly.
2. Closeup of the cleaned bushing
3. Putting in a circlip.
4. Another Piston
5. Front View
6. Apply gasket sealer to both sides of the front gasket. Not too much, just enough to create a film.
7. Take care with the oil seal.
7. Finished engine.